Skip to content

Connect Both Devices Through Tailscale

Introduction

Once Tailscale is installed on your local computer and Windows VPS, both devices should be connected to the same private network.

In this section, we'll verify that both devices are connected and identify the Tailscale IP address assigned to your VPS.

Verify Your Devices

Follow the steps below to check your Tailscale network:

1

Open the Tailscale admin console

Visit the Tailscale admin console.

2

Check your connected devices

Verify that both your local computer and Windows VPS appear in the device list.

Make sure both devices are connected to your Tailscale network.

3

Locate your VPS Tailscale IP address

Find your Windows VPS in the device list and locate its assigned Tailscale IP address.

Identify Your Tailscale IP Addresses

Tailscale assigns each connected device its own private IP address, usually starting with 100..

For example:

Device Tailscale IP
Local computer 100.80.0.2
Windows VPS 100.80.0.3

Example IP addresses

The addresses shown above are examples only. Use the actual Tailscale IP addresses assigned to your devices.

You will need the following information for the firewall configuration in the next section:

  • VPS Tailscale IP: The private IP address assigned to your Windows VPS.
  • Local computer Tailscale IP: The private IP address assigned to the computer you will use to connect.
  • Additional authorised devices: Any other Tailscale devices that should be permitted to access RDP.

Verify Remote Desktop Access

You can now use your VPS's Tailscale IP address to connect through Remote Desktop.

Before changing any firewall settings, confirm that you can successfully establish an RDP connection using the VPS's Tailscale IP address.

Important

Do not proceed with the firewall configuration until you have successfully tested RDP access through Tailscale. Keep your current RDP session open and make sure you have access to your VPS provider's web console in case you lose connectivity.

What's next?

Once you have confirmed that both devices are connected and have recorded their Tailscale IP addresses, you can restrict Remote Desktop access to the private network.

Continue to Restrict RDP Access to Tailscale Only.